CD changer, ista tehnologija kao skoro svaki od njih, pa sam nasao par korisnik klipova i informacija :
https://www.youtube.com/watch?v=nIjlVnTkhHE
I have fixed a hundred of these changers within the three last years. So maybe I can help a litte.
The adjustment of the elevator is very simple: When you are remounting the changer after replacing the black plastic thing, first screw in the three black threaded rods all the way in until they can no longer be turned. Then insert the CD elevator into the chassis. The elevator will be then already adjusted, no further corrections required.
Concerning the BPC (Black Plastic Crab): The one which is normally broken is the one on the right side. The part obviously has to withstand the highest load. I think it would make sense to take an intact part from one of the other corners and put it in the right corner, and then put the glued part in the free left corner where it has less to endure.
Concerning the micro switches: Those who recognize whether a CD has been inserted (seen from above: top left) or those who recognize whether a CD has been drawn into the drawer (seen from above: bottom right) also cause problems from time to time and should therefore also getting cleaned.
The height adjustment on your device also has problems, it has a hard time finding the middle position. There is another part (potentiometer? rotary switch?) below the roller in the lower right corner that can also be cleaned. However, you have to disassemble a lot, which is a bit fiddly to reassamble. In any case, unhook the springs at the front right before you start screwing.
Please excuse my possibly poor English. I'm from Germany.
Skinuo sam i ocistio klapnu gasa
No comments:
Post a Comment